Genesis I.C.E. GBDS450 User Manual download pdf (Page 11)

English

Mounting Belt/Disc Sander

If during operation of the Belt/Disc Sander, there is any

tendencyfor thesanderto slideor "walk"orto tipover,

thenthesandermustbesecuredtoaworkbenchorother

supportingsurfaceusingfasteners(notsupplied)through

thetwoholesinthesanderbase.

ADJUSTMENTS

 WARNING: Always be sure that the tool

is switched off and unplugged from the power

source before adjusting, adding accessories,

or checking a function on the tool

Adjusting the Belt Tracking (FIG 13)

1.Plugthesanderintothepowersource.

2.Turnswitch‘ON’andimmediately‘OFF’,notingifthebelt

tendstoslideofftheidlerdrumordrivedrum.Ifitdidnot

tendtoslideoff,itisTRACKINGproperly.

3. If the sanding belt moves toward the disc, turn the

trackingknob(3)clockwise1/4turn.

4.Ifthesandingbeltmovesawayfromthedisc,turnthe

trackingknob(3)counterclockwise1/4turn.

5. Turn switch ‘ON and immediately ‘OFF’ noting belt

movement.Re-adjusttrackingknobifnecessary.

Positioning Belt Bed (FIG 14)

Thebeltbedlockscrew(4)locksthebeltbedinahorizontal

orverticalposition.

To adjust the belt bed position

1.Unplugthesanderfromthepowersource.

2.Loosenthelockscrew(4)usingAllenwrenchprovided.

3.Positionbeltbedandre-tightenthelockscrew(4).

OPERATION

 WARNING: Always be sure that the tool

is switched off and unplugged from the power

source before adjusting, adding accessories,

or checking a function on the tool

ON/OFF Switch (FIG 15)

1. To turn the sander ON,movetheswitch(1)to

the"ON"position.

2.To turn the sander OFF,movetheswitchtothe

"OFF"position.

3.To lock the switch in the OFF position,remove

thesafetykey(2)fromtheswitch.Storethekeyina

safeplace.

FIG 12

FIG 13

FIG 14

FIG 15

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Comments to this Manuals

No comments

Genesis I.C.E. GBDS450 User Manual Page 11

Comments to this Manuals